541.341.4644

541.342.6034 fax

info@GriceIndustries.com

Grice Industries

Main Office/Sales & Service

1145 Chambers Street

Eugene, OR.  97402

INSTRUCTIONS / VIDEO HELP

ADDITIONAL PERSONALIZED INSTRUCTION CAN BE FURNISHED UPON REQUEST

✧✧

 

POLY/PVC PIPE REPLACEMENT

 

 

 

 

Expose corp on water main. Disconnect damaged line and remove meter stop.

Thread GRICE PIPE REPLACEMENT TOOL cable through the damaged line and

connect new service to the threaded part of the tool. Pull slack out of cable line

 and attach cable grip to it. As cable is pulled, the GRICE PIPE REPLACEMENT

 TOOL will split the old poly pipe and pull the new line behind at the same time.

 

 

 

 

 

LEAD/GALVANIZED PIPE REPLACEMENT

 

 

 

 

 

 

 

Expose line on both sides of street. Thread GRICE PIPE REPLACEMENT TOOL

cable through damaged line and connect new service to the threaded part of the

tool. NOTE: The GRICE PIPE REPLACEMENT TOOL will not split lead or galvanized, but

will push the old service out intact, allowing new service pipe to follow in its place.

 

 

Methods of Pulling Cable

The GRICE PIPE REPLACEMENT TOOL can be pulled from main or meter side of street. A backhoe, truck or winch can be used to pull the GRICE TOOL through the damaged service while simultaneously laying new pipe.

 

A Word from Our Wire Rope Supplier

"Severe bending and curling over a tight radius or angle will cause damage to the wire rope. This action would have a severely detrimental effect on the life of the wire. The relative movement of each individual strand and wire must remain within a radius not to be limited to less than 19 times the diameter of the wire. In most cases, 19 x .385 or 7.315 inches of minimum ratio between the rope and the curvature of excessive bending not only restricts correct wire support but also limits the relative movement of the adjacent individual strands. In order for the wire to complete a bend, two factors are related for continued wire rope life. One is the initial bend within its correct radius and the other is the normalizing of the wires in the straightened or passive position. If either of these is altered, premature rope life will come into play."

Grice Industries is the Home of The Original Trenchless Pipe Replacement Tool

Trademark, Brand, and Pipe Replacement Tool are property of Grice Industries.